|
Protocol »
Internet Protocol v6
(Info)
Viewing 1 - 9 of 9 captures
OSPFv3_with_AH.cap (10.7 KB)
The adjacency between R1 and R2 in the 2001:db8:0:12::/64 subnet is configured with IPsec AH authentication. Note the inclusion of an IPsec AH header immediately following the IPv6 header of each OSPF packet.
OSPFv3_multipoint_adjacencies.cap (11.5 KB)
The frame relay link connecting routers 1, 2, and 3 has been configured as a point-to-multipoint network with broadcast capability. Router 3 forms OSPFv3 adjacencies with routers 1 and 2, but no DR or BDR is elected.
OSPFv3_NBMA_adjacencies.cap (12.9 KB)
Router 3 forms OSPFv3 adjacencies with routers 1 and two across the non-broadcast multiaccess (NBMA) frame relay link.
OSPFv3_broadcast_adjacency.cap (5.4 KB)
Routers 1 and 2 form an OSPFv3 adjacency across their common Ethernet link (2001:db8:0:12::/64).
IPv6_NDP.cap (2.1 KB)
Neighbor Discovery Protocol (NDP) uses ICMPv6 to perform duplicate address detection and address resolution. Also includes multicast listener reports. IPv6_in_IP.cap (1.5 KB)
ICMPv6 echos across an IPv6-in-IP tunnel. EIGRPv2_subnet_transition.cap (5.3 KB)
R4's 2001:db8:0:400::/64 subnet goes down, then comes back up roughly thirty seconds later. Capture perspective from R1's 2001:db8:0:12::1 interface.
EIGRPv2_adjacency.cap (4.1 KB)
Routers 1 and 2 form an EIGRPv2 adjacency and exchange IPv6 routes.
ICMPv6_echos.cap (1.3 KB)
Five ICMPv6 echo requests and their subsequent replies between routers 1 and 2. Viewing 1 - 9 of 9 captures
|
Navigation
Armory
Online Toolbox
|